top of page

Sea & Sea YS-D2J

Our Price $POA

Maximum guide number is a powerful 32 (ISO 100, meter). Recycle time is only 1.5 sec. The YS-D2 is powerful enough to illuminate a wide area, even under very bright conditions with plenty of natural sunlight. During macro photography, where subtle exposure control is required, manual mode can easily be selected and the guide number quickly adjusted as low as 1.
 

DS-TTL ll automatic exposure control with improved accuracy and stability

 

SEA&SEA’s own automatic exposure control system, DS-TTL ll, has been further improved. Tuning light emitting timing in detail and adding light emission detection function, the accuracy of automatic TTL exposure has been noticeably improved. Previously, TTL photography was difficult with the lens’s aperture wide-open (maximum aperture) and images were likely to be overexposed. It is now possible to give a low powered flash so the correct exposure can be easily achieved with the YS-D2.

The Focus light can be adjusted in 2 steps

 

The strobe is equipped with a target light (approximately 100/300 lumen). In use (target light switch in ON position), the light will be automatically turn off when the strobe fires and will automatically turn back ON after 0.5 sec.

Guide Number (ISO 100/m) (land)] : 32, 24 (with Diffuser 100 attached), 20 (with Diffuser 120 attached)
Beam Angle : 80°x80°  (without Diffuser), 100°x100°(Diffuser 100), 120° x 120° (Diffuser 120)
Batteries : 4xAA A: 6V Ni-MH: 4.8V
Number of Flashes : A: 150 Ni-MH: 200
Recycle time (full) : A: 3.0 sec. Ni-MH: 1.5 sec.
Color temperature : 5600K
Color temperature w/diffuser : 5250K
Depth rating : 100m  / 330ft
Dimensions (WxHxD) : 89x111x141mm / 3.5 x 4.8 x 5.6 inches (excluding YS-base) 
Weight : 618g / 21.0oz (w/o batteries) (excluding YS-base)
Underwater weight :  Approx.+40g / 1.4oz (incl. batteries)

Exposure control: DS-TTL II,  Slave TTL, Light level control dial (GN): 1 / 1.4 / 2 / 2.8 /4 / 5.6 /8 / 11 / 16 / 22 / 32 (11 steps)
Pre-flash control: Equipped with pre-flash cancel mode
DS-TTL II function
Slave function
Auto power OFF function
Sync cord: 5-pin Sync cord/N, Fiber-Optic Cable
Over-pressure relief valve
LED target light (output is adjustable in 2 steps)
Audible charge signal

*1 Number of flashes and recycle time depends on the battery brand, temperature and frequency of use.
*2 Number of flashes and recycle time of Ni-MH batteries were tested on 2400 mAh batteries.

bottom of page